PicoCAP SERIES

PICOCAP: PCAP SERIES

PCap01 has been the first chip of the PICOCAP ® product line and was introduced to the market in early 2010. Now, in early 2013 mass production samples of the successor PCap02 have been released (full mass production planned in Q2/2013) with a particular focus on humidity applications. Also in early 2013 engineering samples of PCap03 for highest performance applications will be available.



DescriptionVersionSizeDownload
Development Support PCap04:
Evaluation System for PCap04
V1.04MBPCAP04EVAL- DS.PDF
Datasheet PCap04:
General Data
V1.03.2 KBPCAP04.PDF
Datasheet PCap02, Vol. 1:
General Data and Front-End
V1.62.6MBDB_PCap02A_Vol1_en.pdf
Datasheet PCap02, Vol. 2:
Digital Signal Processor
V0.21.6MBDB_PCap02A_Vol2_en.pdf
Datasheet PCap02 Eval System:
Evaluation System for PCap02
V0.0990kBDB_PCap02-EVA-Kit_en.pdf
Datasheet PCap02 Eval System:
Evaluation Software for PICOCAP Devices
V0.02MBDB_PCap02plus_en.pdf
Datasheet PICOCAP DEVICES:
Assembler Software PICOCAP Devices
V0.0750kBDB_PCap-Assembler_en.pdf
Datasheet PCap02, Linearize:
Description of Linearization Firmware
V0.21.2MBDB_PCap02_Linearize_en.pdf
Datasheet PCap01:
Single-chip solution with standard firmware
V0.65MBDB_PCap01Ax_0301_en.pdf
Datasheet PCap01:
Single-chip solution for humidity measurement
V0.34MBDB_PCap01AK-0101xx_en.pdf
Datasheet PCap01:
Description of PCap01 DSP and Assembler
V0.23MBDB_PCap01_DSP_e.pdf
Datasheet PCap01:
General evaluation kit for PCap01
V0.32.6MBDB_PCap01-EVA-KIT_en.pdf
Datasheet PCap01:
Description of humidity measurement demonstrator
V0.13MBDB_PCap01_HUM_DEMO_en.pdf
Datasheet PCap01-Touch:
Very-Low-Power IC for Capacitive Touch Sensor Solutions
V0.11.3MBDB_PCap01_Touch_en.pdf
DescriptionVersionSizeDownload
Screencasts PCap01:
2:44 min. webcast introduction into PCap01 Evaluation Kit
-7MBPCap01_Evaluation-Software_en.zip
Screencasts PCap02plus:
9:37 min. webcast introducing a Sensor Scaling + PDM / PWM output with PCap02
-26MBPCap02plus-Scaling-PDM-PWM_en.zip
DescriptionVersionSizeDownload
Software PCap04:
Evaluation software for PICOCAP Devices
Full installer package incl. drivers
1.2.7297MBPCap04-EVA-SW_W7.zip
Software PCap04 (32-bit):
Using our DLL combing with your own software.
ZIP package incl. e.g. header file, example c-code
1.0423kBPCap04-DLL-Library.zip
Software PCap04 (64-bit):
Using our DLL combing with your own software.
ZIP package incl. e.g. header file, example c-code
1.0378kBlinearize_r01.zip
Software PCap02:
Evaluation software for PICOCAP Devices
Full installer package incl. drivers
1.3.1168MBPCap02plus.zip
Software PCap01:
Evaluation software for PCap01-EVA-KIT and PCap01-HUM-EVA
Full installer package incl. drivers
0.80150MBPCap01-EVA-SW_W7_XP.zip
Software PCap01:
Assembler software for PCap01, installer package
V20.4160MBPCap01_Assembler.zip
Software PCap01:
Standard firmware for PCap01A
03.01.0225kPCap01_standard.hex
Software PCap01:
Firmware for humidity+temperature measurement
01.01.0425kPCap01_humidity.hex
Software PICOPROG V3 (V2.0):
Driver Installer Stand-Alone
R113.1MBPicoProg_v2_Driver_Installer_Stand-Alone.zip
PICOSTRAIN Measurement Principle

The PICOCAP measuring principle shows a new approach to capacitance measurement. For this purpose the sense capacitor and a reference capacitor are connected to a resistor, forming a low-pass filter. Sense and reference capacitor should be in the same range to minimize gain drift. Practically there is no limit for the capacitor value. Sensors from nearly 0 fF up to tens of nF can be measured. The PICOCAP devices also support differential sensors with inside linearization.

The capacitors are charged to the supply voltage and then discharged through the resistor. The discharge time down to an arbitrary trigger level is measured with ultra-high precision using a TDC (Time-to-Digital Converter).

This measuring process is repeated in time-multiplex with both Capacitors, using the same resistor and the same comparator. Calculating the ratio of the results will turn out the absolute values and temperature dependencies of the resistor and the comparator.

The Compensated Mode offers the solution for highest resolution applications with low offset and extremely low gain drift. The capacitors are connected floating, not referenced to ground. They are switched alternately to the resistor by an integrated analog switch. Additional patented circuits and algorithms compensate for parasitic capacities. Parasitic capacities would have a negative effect on the gain drift over temperature. The compensation results in a very low gain drift over temperature down to 0.5 ppm / K. It is much better than the intrinsic gain drift of most sensors.

General Circuit
(click to enlarge)

Cycle Time
(click to enlarge)

TypePart numberPackageRoHS compl.Shipping package
PCap02:
PCap02ADiceYes
PCap02AEQFN32Yes
PCap02-EVA-KITSystemYesBox
PCap01:
PCap01AMNR 1613DiceYes
PCap01ADMNR 1793QFN32Yes
PCap01AKMNR 1795QFN24Yes
PCap01-EVA-KITMNR 1912-01SystemYesBox
PCap01-HUM-EVAMNR 1796SystemYesBox
PCap01-HUM-DEMOMNR 1792SystemYesBox

ADDITIONAL INFORMATION